here r some answers :






& here are some web sites that may help u

binary-converter

Hex Color Tutorial


it's better to double check those answers < just to be sure

good luck bro.

May Allah Help U

and here r the rest of answers:

The input voltage signal to the chip select (CS) pin on a memory chip must be ....address enable input is active (1).... in order to turn the memory chip on

2- The part of the computer that conveys data and instructions between the microprocessor and memory..BUS

3- TLA for the part of the graphics adapter that converts the stream of graphics binary representing pixels into an analogue voltage signal which can be sent down the cable to the computer monitor..VGA

4- The acronym for voltage memory devices that are typically used for short term storage in a computer.. RAM

5- What happens when a numerical operator causes a result to go beyond the bounds of a fixed length number system
RUN TIME ERROR
6-The minimum number of binary bits needed to store any one of 8 binary number from 0-7
2^x = some number
وتجد الاكس
7- The hex code for purest green colour on a computer monitor
00 FF 00

8- The binary digits 1111000000001101 are *****alent to what four digit hexadecimal code?
F00D

9- 24 bit - colour can produce 16 ..milions. different colours through combination of RGB


10- Hexadecimal form of the binary number 1100111100010011
CF13

11- TLA for a display technology that uses Polaroid technology
ZINK stands for Zero Ink

12- TLA for a computer monitor
LCD


13- File ..ALLOCATION. Table , the 'table of ******* ' of hard disk with information about the whereabouts of file on the disk


14- A region of short term memory that a microprocessor accesses in a firs in last out fashion
LIFO
15- The .clock rate.. speed is the ' speed ' at which a microprocessor executes instructions


16- The 4-digit hexadecimal *****alent for the 16-bit binary code 1101111010101111
DEAF

17- The hex code for the purest red in a computer monitor
FF 00 00

18- A radial section of one side of a single platter
Striping data



19- A general name for parallel data cable used to connect long term storage devices such as DVD drive to the motherboard
ATA

20- The hex code for the purest blue in a computer monitor
00 000000ffFF

21- The TLA for where all the number manipulation are done in a microprocessor
ALU (arithmetic logic unit)

22- The hex code for brightest white in a computer monitor
FF FF FF

sorry i just put them withe out order
coze am buzy a little bit
and again >> check the answers
coze am not sure 100%
God Luck

ّّّّّ

تسلم ايديك:):):):):) تسلم ايديك:):):):):) تسلم ايديك:):):):):)

وانا ساعدوني احل هالاسئله
1-write a program that reads an integer and print it in the horizontal order of the screen.

2- write a program that contains function yard to kilo() to convert yard to kilometers and to yard () kilometers to yard.

1 yard =0.9114 kilometer
3-Write a program that calculates the volume of sphere , given the radius by reading the radius from a file and write the result to another file (output.txt).
Volume=4/3Πr3
4-Write a program that asks the user to type a positive integer . when the user types a negative value the program writes ERROR and asks for another value .when the user types 0 that the last value has been typed and the program must write the average of the positive integer . if the number of typed values is zero the program writes NO AVERAGE.

5-Imagine a publishing company that markets both book and DVDs versions of its works. Create a class publication that stores the title and price of a publication . from this class derive two classes: book , which adds a page count and dvd , which adds a playing time in minutes . each of these three classes should have a getdata () function to get its data from the user at the keyboard and a putdata () function to display its data.


Write a min () program to test the book and tape class by creating instances of them , asking the user to fill in their data with getdata () and then displaying the data with putdata().

6- Start with publication , book and dvd classes as in Q5 . add a base class sales that holds an array of three floats so that it can record the dollar sales of a particular publication for the last three months . include a getdata() function to get three sales amounts from the user and a putdata () function to display the sales figures . after the book and dvd classes so they are derived from both publication and sales. An object of class book or tape should input sales data along with its other data. write main() program to create a book object and a tape and exercise their input/output capabilities.